Assistance  ICO Support & Sensors  How to widen the contact strips on a sensor ?

How to widen the contact strips on a sensor ?

STEP 1 : Take ICO out of the water

Take ICO out of the water and dry it correctly. 

STEP 2 : Open the cover

Remove the blue cover with the help of the tool provided.

 

How to open and close ICO?

STEP 3 : Turn off ICO

Press and hold the button, the light will flash yellow once : ICO is switched off.

How to switch off ICO ? 

STEP 4 : Remove the sensor

With the blue tool which is found in your ICO’s box, remove the desired sensor.

Blue = pH

Yellow/Orange = Redox (ORP)

Grey = Conductivity

 

How to replace a sensor? 

STEP 5 : Widen the contact strips

With the help of a small knife, widen one or two contact strips.

STEP 6 : Replace the sensor

 

Replace the sensor with the contact strips widened.

How to replace a sensor?

 

STEP 7: Turn on ICO

Press and hold the button, the light will flash green 3 times : ICO is turned on.

How to switch on ICO? 

STEP 8 : Replace the cover

Replace the blue cover.

How to open and close ICO?

STEP 9: Put ICO back in the water

Put ICO back in the water and await the next readings.

Was this page helpful ?

[Total: 12 Average: 2.8]

Do you have any other questions ?

Contact Customer Support

Pin It on Pinterest

0
    0
    Your Cart
    Your cart is emptyReturn to Shop